|
|
Go to page [Previous] 1~2~3 | ||||||||||
illusionman2 Special user 991 Posts |
Quote:
On Mar 23, 2017, Dan C wrote: I would think you would be OK if it is yours or in public domain--- I tell how I build but not why, I think what I post would be of little interest to the lay public. |
|||||||||
illusionman2 Special user 991 Posts |
Quote:
On Mar 24, 2017, illusionman2 wrote: |
|||||||||
illusionman2 Special user 991 Posts |
I mounted the roller blinds to a 1/2 inch strip of plywood and put industrial strength Velcro on the back for mounting.
http://i177.photobucket.com/albums/w221/......6sap.jpg the next pix shows where I placed the industrial strength Velcro in side the prop http://i177.photobucket.com/albums/w221/......cxhr.jpg the roller shades were mounted inside the prop. |
|||||||||
illusionman2 Special user 991 Posts |
Could not get the pin striping (I wanted) locally so I ordered it on line.
|
|||||||||
illusionman2 Special user 991 Posts |
Got the pin striping done-- Zig Zag finished-- I will try to take a picture and get posted before next Mon.
|
|||||||||
illusionman2 Special user 991 Posts |
FINISHED__DONE---
http://i177.photobucket.com/albums/w221/......t86c.jpg and http://i177.photobucket.com/albums/w221/......wegp.jpg It should zag over that far with me in it- I will post a pix of me in it when I get. |
|||||||||
Zlwin Chew Elite user Malaysian Magician with 437 Posts |
Quote:
On Apr 7, 2017, illusionman2 wrote: You did an amazing job!!! |
|||||||||
The Magic Cafe Forum Index » » The workshop » » Starting a new Zig Zag Build (3 Likes) | ||||||||||
Go to page [Previous] 1~2~3 |
[ Top of Page ] |
All content & postings Copyright © 2001-2024 Steve Brooks. All Rights Reserved. This page was created in 0.02 seconds requiring 5 database queries. |
The views and comments expressed on The Magic Café are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic. > Privacy Statement < |