|
|
ggarcia Veteran user San Antonio Tx 395 Posts |
Has anyone ever used derek rutt's get up table. I was thinking about getting this but I am wondering on the strength of the table to actually set things on it.
|
four elements New user 91 Posts |
I was interested in it also but I am hesitant to buy it because of the overseas shipping charges.
|
Mumblemore Inner circle 1429 Posts |
I have never used these guys, but noticed this e-dealer carries Rutt stuff at 20 percent discount
http://www.totaldiscountmagic.com/index.htm Also, I've purchased some of his tricks from Hank Lee |
Derek Rutt Creations Regular user thailand 172 Posts |
Hi there ggarcia......just to answer your question about placining props on the table .....when it is set in the upright position you can place props on it but I would only recommend fairly light ones it is strong enough to hold the props but in order for it to collapse obviously it will waver a bit if pushed as the upright pieces will give a little as the wood has to be light in order for it to get up again,but it is strong enough to hold them until you press the lever on the floor with your foot when it will fall down .
Yes the shipping is quite costly from here but if I sell retail then I can subsidize it to make it reasonable. The total weight in the case is 8.5 kilos before packaging. I hope this helps Derek
Hope this helps. Creation is life
www.derekrutt.com |
The Magic Cafe Forum Index » » Boxes, tubes & bags » » Derek Rutt - Get up table (0 Likes) |
[ Top of Page ] |
All content & postings Copyright © 2001-2024 Steve Brooks. All Rights Reserved. This page was created in 0.01 seconds requiring 5 database queries. |
The views and comments expressed on The Magic Café are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic. > Privacy Statement < |