|
|
gimpy2 Special user 960 Posts |
Went to change a blade on a Bosch miter saw. Nut came off fine but the inner washer, the part that goes into the arbor hole on the back side of the blade is stuck. You can’t get the blade off to work on it. It’s like the blade is welded to the inner washer inside the arbor hole. Anyone have a hack, have tried heat and wd40.
Gimpy
www.gimpysmagic.com |
imgic Inner circle Moved back to Midwest to see 1337 Posts |
You might want to post this in The Workshop room...likely to get help there
"Imagination is more important than knowledge."
|
The Magic Cafe Forum Index » » Not very magical, still... » » Blade stuck (0 Likes) |
[ Top of Page ] |
All content & postings Copyright © 2001-2024 Steve Brooks. All Rights Reserved. This page was created in 0.01 seconds requiring 5 database queries. |
The views and comments expressed on The Magic Café are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic. > Privacy Statement < |