The Magic Café
Username:
Password:
[ Lost Password ]
  [ Forgot Username ]
The Magic Cafe Forum Index » » Not very magical, still... » » Blade stuck (0 Likes) Printer Friendly Version

gimpy2
View Profile
Special user
950 Posts

Profile of gimpy2
Went to change a blade on a Bosch miter saw. Nut came off fine but the inner washer, the part that goes into the arbor hole on the back side of the blade is stuck. You can’t get the blade off to work on it. It’s like the blade is welded to the inner washer inside the arbor hole. Anyone have a hack, have tried heat and wd40.
imgic
View Profile
Inner circle
Moved to Seattle to see
1193 Posts

Profile of imgic
You might want to post this in The Workshop room...likely to get help there
"Imagination is more important than knowledge."
The Magic Cafe Forum Index » » Not very magical, still... » » Blade stuck (0 Likes)
[ Top of Page ]
All content & postings Copyright © 2001-2021 Steve Brooks. All Rights Reserved.
This page was created in 0.1 seconds requiring 5 database queries.
The views and comments expressed on The Magic Café
are not necessarily those of The Magic Café, Steve Brooks, or Steve Brooks Magic.
> Privacy Statement <

ROTFL Billions and billions served! ROTFL