I bought Mr.Danger and I went to the site to download the English instructions but don't see anywhere on the site to do that. Any help would be appreciated. Thanks

Tenyo English Instructions

PM sent

Thank you to both of you. Much appreciated.

I had the same problem.
Thank you guys.

Thanks very much! I bought my Mr. Danger from a fellow Café Member, who dutifully sent me a printout of the English instructions, but since it wouldn't fit well into the trick box, it became separated from the trick and was ultimately lost. Now I have printed out a new copy and am a happy mage once again! (smile)

PS - My little plastic figurine sticks quite tightly in the bottom of its form-fitting case and so does not drop out freely when the case is inverted, as it does in the Tenyo demo video. My trick came with a small sheet of additional instructions labeled 'SUPPLEMENT' (in both English and Japanese), which provides the following advice:

"Precautions for handling
"The gimmick will not work properly if the figurine is not inserted all the way to the bottom of the indentation. Push the figurine all the way to the bottom. When removing the figurine, if the figurine does not fall out with the case upside down, insert the sword into the hole at the bottom and push it out."

While I am grateful for the manufacturer's workaround provided in the above supplementary instructions, I do find it somewhat irritating that my figurine does not fall out of the case freely. I have tried carefully scraping off excess plastic from around the edges of the figurine with a razor knife to no effect. If anyone can suggest a solution to this little problem, please let me know, thanks.

Did you try sanding all edges of the figure with some sanding paper? I'm considering buying this gimmick, but if I hear that the figure does not fall out freely as seen in the video, I might skip this one.

Also, I've seen a slightly different routine where the figure is hold in place already with one sword (instead of the clip). If you start that way, there is no need for the two clips. Just add all other swords, remove them again, and open the case. I think the clips give away big part of the trick. If you can leave those out of the routine, it looks better...

Great idea!

Upnxrawk sent me a black one he 3D printed. It's thinner than the orange man, and almost has a black art feel!