I have acquired a set of two single rings and one Porper Ghost Ring. I have the instruction book and it says you should adjust the gap on the ghost ring so that the loose side of the gap/joint is gently touching the end of the ring.

I have found that if the gap is completely closed the small piece that moves doesn't work well.

The best I can do is to leave a very small gap so that part is free to move.

Is it possible to adjust the ring so there is NO gap and still have it operate smoothly?

I don't think so. The gate needs a little room to swing.

I have the mini set, and the gaff broke - does anyone know who might be able to repair this?

Thanks -

Mark